Differential scanning calorimetry (DSC) measures the heat absorbed or released by a protein solution as it is heated, and it is the only routine method that reports the thermodynamics of unfolding directly rather than inferring it from a spectroscopic signal. Where CD and nanoDSF track a reporter (ellipticity, intrinsic fluorescence) and assume it scales with the fraction unfolded, DSC measures the excess heat capacity (Cp) of the transition itself. That makes it the reference method for thermodynamic stability — and the one against which the assumptions of the faster techniques are judged.
What the thermogram reports
As a protein unfolds during a controlled temperature ramp, the breaking of intramolecular interactions and the exposure of buried surface produce a peak in the excess heat capacity. The integrated area of that peak is the calorimetric enthalpy of unfolding (ΔHcal), the temperature at the peak maximum for a two-state transition is the melting temperature (Tm), and the shape of the peak carries the van 't Hoff enthalpy (ΔHvH). The ratio ΔHcal/ΔHvH — the van 't Hoff ratio — is close to 1 for a genuine two-state transition and deviates from 1 when intermediates accumulate or when the transition is coupled to oligomer dissociation or aggregation. This ratio is one of DSC's most valuable outputs, and it is information that calorimetry-aware reviewers expect.
From Tm and ΔH one can compute the free energy of unfolding at a reference temperature, typically 25 °C, by extrapolation — a value that quantifies how much more stable a mutant or a reformulated sample is, and that no rapid screening method provides without assumptions.
Sample preparation
- Concentration: typically 0.2–1 mg/mL for a microcalorimeter with a 0.5 mL cell; higher concentration improves signal-to-noise but risks aggregation. Determine the exact concentration accurately, because ΔH is reported per mole of protein.
- Buffer matching: the reference cell must contain the exact formulation buffer, matched to the sample by dialysis or by buffer exchange into the same batch. Mismatched buffer produces a sloping baseline that corrupts the integration.
- Degassing: degas both sample and reference thoroughly. Dissolved gas forms bubbles on heating and produces sharp spikes in the thermogram.
- Purity and homogeneity: aggregates present before the scan contribute their own irreversible transitions; clarify by centrifugation or filtration (0.22 µm) and run SEC first if aggregation is suspected.
Scan parameters
| Parameter | Typical setting |
|---|---|
| Temperature range | 10–20 °C to 90–110 °C, adjusted to the expected Tm |
| Scan rate | 1 °C/min (0.5–2 °C/min acceptable; slower improves equilibrium) |
| Cell | Fixed or capillary cell, matched sample and reference volumes |
| Pre-scan equilibration | 5–15 min at the starting temperature |
| Reference buffer | Same formulation as the sample, matched by dialysis |
Scan rate is not a free parameter to optimise for speed: a fast ramp shifts the apparent Tm because the protein is not at thermal equilibrium. Use the slowest rate that keeps the run within a reasonable time, and use the same rate for all samples in a comparison.
Reversibility
After the heating scan, cool the cell and run a second heating scan on the same sample. If the second thermogram reproduces the first, unfolding is reversible and the thermodynamic parameters are meaningful. If it does not — and for many antibodies and multi-domain proteins it will not — the process is irreversible, and the reported Tm should be labelled as an apparent value. Reversibility is the single most important determinant of whether DSC data can be interpreted thermodynamically, and it must be reported, not assumed.
Data analysis
- Subtract the reference (buffer vs buffer) scan to obtain the baseline.
- Fit the excess heat capacity curve. For a single two-state transition, use a two-state model; the fit returns Tm and ΔHcal.
- For multi-domain proteins (e.g. mAbs), fit the thermogram as the sum of two or three independent transitions to obtain per-domain Tm values. The CH2 domain of a mAb is typically the least stable and melts first, followed by the Fab and CH3 domains.
- Report ΔHvH and the van 't Hoff ratio; a ratio far from 1 flags non-two-state behaviour that should temper any thermodynamic claim.
- Compute ΔG of unfolding at 25 °C by extrapolation, and report it with the uncertainty from replicate scans.
Troubleshooting
- Spikes or discontinuities: bubbles from inadequate degassing, or the sample precipitating during the scan. Degas, lower the concentration, or add a mild surfactant if compatible with the formulation.
- Sloping or drifting baseline: buffer mismatch between cells. Re-dialyse the sample against the reference buffer.
- No reproducible second scan: irreversible aggregation. Reduce concentration, or accept the apparent Tm and report irreversibility explicitly.
- van 't Hoff ratio far below 1: intermediates or coupled oligomer dissociation. Do not force a two-state fit.
Where DSC fits alongside CD and nanoDSF
DSC requires more protein and more instrument time than CD or nanoDSF, but it answers a different question: not "at what temperature does the optical signal change?" but "how much heat does unfolding absorb, and is the transition two-state?" In a stability study, a sensible workflow is to screen many variants quickly by nanoDSF or CD, then confirm the key candidates — and any stability claim that will be published — by DSC with a reversibility check. When the three methods agree on Tm, the stability picture is robust; when they disagree, the disagreement itself is informative and usually points to aggregation or a non-two-state transition.
References
- Privalov PL. Stability of proteins: small globular proteins. Adv Protein Chem. 1979;33:167–241. doi:10.1016/s0065-3233(08)60460-x
- Privalov PL, Potekhin SA. Scanning microcalorimetry in studying temperature-induced changes in proteins. Methods Enzymol. 1986;131:4–51. doi:10.1016/0076-6879(86)31033-4
- Privalov PL. Microcalorimetry of proteins and their complexes. Methods Mol Biol. 2009;490:1–39. doi:10.1007/978-1-59745-367-7_1
- Seelig J, Schönfeld HJ. Thermal protein unfolding by differential scanning calorimetry and circular dichroism spectroscopy: two-state model versus sequential unfolding. Q Rev Biophys. 2016;49:e9. doi:10.1017/s0033583516000044
- Greenfield NJ. Using circular dichroism collected as a function of temperature to determine the thermodynamics of protein unfolding and binding interactions. Nat Protoc. 2006;1(6):2527–2535. doi:10.1038/nprot.2006.204
- Schuck P. On the analysis of protein self-association by sedimentation velocity analytical ultracentrifugation. Anal Biochem. 2003;320(1):104–124. doi:10.1016/s0003-2697(03)00289-6